Wood-mizer 1992 LT40HD Operator's Manual download pdf (Page 100)

Troubleshooting Guide

Power Feed Circuit Troubleshooting

4-8 HD92doc042701 Troubleshooting Guide

circuit. If the power feed motor is a Wood-Mizer replacement, replace the circuit board.

CL - This light indicates an extreme overload condition of the power feed motor or a short

in the wiring between the motor and circuit board. The light will flash about once every

second and deactivate the feed system until the problem is corrected.

TEMP - When lit, this light indicates the temperature of the output circuit is too high and

will shut off the circuit. Once the circuit cools, the light will go off and the feed will become

operational. Temperatures become too high when the power feed motor is overloaded.

OUT - This light normally dims and brightens at the same rate as the IN light when the

feed rate switch is turned up and down. If the OUT light does not correspond with the IN

light, replace the circuit board.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 139 140

No comments

Wood-mizer 1992 LT40HD Operator's Manual Page 100