Wood-mizer 1992 LT40HD Operator's Manual download pdf (Page 36)

Setup & Operation

Tracking The Blade

2-8 HD92doc042701 Setup & Operation

2.6 Tracking The Blade

Make sure the middle blade housing cover is closed and all persons are clear of the open

side of the saw head.

Start the engine (or motor). Pull lightly on the clutch handle, rotating the blade until the

blade positions itself on the wheels.

See Figure 2-6. Position 1 1/4” wide blades so the gullet is 1/8" (3.0 mm) out from the

edge of the blade wheel (±1/32 [.75 mm]). Position 1 1/2” blades so the gullet is 3/16” (4.5

mm) out from the edge of the blade wheel (±1/32 [.75 mm]).

To adjust where the blade travels on the blade wheels, use the cant control handle shown

in Figure 2-5.

If the blade is too far out, back the blade onto the wheel by turning the cant control coun-

terclockwise. If the blade is too far in, turn the cant control clockwise until the gullet of the

blade is is the correct distance from the front edge of the wheel.

FIG. 2-6

SM0044C

3/16" (4.5 mm)

± 1/32" (0.75 mm)

11/2"

Blade

1/8" (3.0 m)

±1/32"(0.75mm)

11/4"

Blade

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 139 140

No comments

Wood-mizer 1992 LT40HD Operator's Manual Page 36